3D Printed Wire Stop Motion Animation Armature Kit



Build wire based armatures fast and easy with 3D Printed high strength ABS components developed by Julian Clark Studios.

Easy to use "slot-in-and-secure" parts - just cut the supplied pre-twisted armature wire to your desired length, ready in minutes!

  • Hinge Jointed Knees for greater control over walk cycles, strength and stability
  • Toe pivot feet with M3 threaded tie downs to secure to your set
  • Torso and Hip joints with integrated "Slot-In" rigging points, ready to accept 3.97mm (5/32") square rig arms
  • Handset with individual finger slots - easy to build, easy to replace
  • Simple Head joint, acts as a base to add your puppet head
  • Complete with pre-twisted Armature Wire ready to cut, slot in and secure to your own design
  • 3D printed ABS plastic joints x 9
  • M3 x 4mm Set Screws x 40
  • M2 x 8mm Cap Head Bolt x 3
  • M2 x 10mm Cap Head Bolt x 3
  • M2 Hex Nut x 6
  • M3 Hex Nut x 4
  • Pre-Twisted 1.6mm Armature Wire x 1 metre
  • Pre-Twisted 1mm Armature Wire x 1 metre



Brand JulianClarkStudios
Weight 0.33kg